Verbatim 43667 Blank DVD+R 8x Dual Layer Print Disc / 25 Pack

@ BigBadKev: using shoddy burners would do that to the discs....use a better burner like a liteon, phillips, samsung, sony, pioneer etc...
verbatium all the way....not one coaster and when it has burner was dying or fault on my end...would highly recommend

I tried other brands and many failed, this is perfect everytime :) however they are expensive but worth saving your orignal copy from getting damaged.

These are the only disks that you wanna be using. The best by far, never had a coaster in 5 years. Price has gone up though, was 17.99. Super deal

got 3 packs of 25. used 25 so far and not one has failed. purchased a pack of tdk and only 5 from 25 worked error free. these discs are probably the best out there

Top quality discs at a low price, I've used around 30 of these discs with not 1 fail. Also for anyone interested these are made in Singapore, which I hear are the best ones :-) Thanks Play!

I have burnt over 100 of the discs for 360 backup and had zero failures.
Good scratch resistance too .

All of them have worked for me.
Only a couple did not work correctly, and that was due to an error on my half. (Wrong data type during burning)

So yeah.. great buy. Oh, and the printer is ace for these. Put em in and put custom artwork on! Great for your wedding films!

Unlike what the below review says i have burnt 75 of these disc so far and not had a problem with a single one of them! These are quality disc that want fail you!

I recently bought this 25 disk spindle, and so far only 5 out of 16 haven't given me errors, and I've tried two different burners (Matsushite and Optiarc) and ImgBurn and CloneCD. When I bought the spindle of 10 (43666) I didn't get a single burn issue.

These Verbatim discs use the newer MKM-003-000 dye and are rated at 8X. I've done test burns at 4X, 6X and 8X and the 8X burns give the best results on my Optiarc AD-7200S burner based on the results of DVDInfoPro PIPO scans. Having burned over 200 Verbatim dual layer discs (a mix of these and the older 2.4X media), I haven't had a single coaster or dodgy burn, so while they may cost a little more than some other brands, IMO they're totally worth the money. The spindles I've bought from Play were made in Singapore. Also, unlike the older 2.4X media, they're full face printable so they don't have the clear ring around the centre hole.